广东变压器-可控硅无触点电化退电装置

广东变压器-可控硅无触点电化退电装置     广东变压器-可控硅无触点电化退电装置
    上的工件通常是用广东变压器来吸持的。工件磨好后,由于广东变压器反向去电不尽,剩电仍较大,工件难以取下,要手扳,木槌敲,花劳力、费工时,而且往往容易损坏的工作台面和工件。取下的工件还需一道进行去电的工序,影响了的生产效率和生产产品质量。
    变压器有限公司广大职工遵照毛主席关于“我们必须打破常规,尽量采用先进技术”的教导,对广东变压器上原来的电气线路进行了革新,应用了可控硅新技术,通过三个多月的反复试验,在七一年九月份初次试制了可控硅无触点吸退电装置。安装在 MM7132上,经过多年的探索与不断改进使用经验证明,该装置工作可靠,性能良好。
    The workpiece on the surface grinder sorption of electromagnetic sucker. After the workpiece grinding, due to the electromagnetic chuck reverse demagnetization different, the remanence is still large, the workpiece is difficult to remove, to lever mallet knock, spend labor costs of working hours,often damage to the grinder work surfacethe workpiece . Remove the workpiece needs to a demagnetization process, affecting the production efficiencyproduct quality of the surface grinder.
    Laiwu City Luyue Electromagnetic Equipment Co., the vast majority of workers in accordance with Chairman Mao "We must break the routine, try using the advanced technology to teach,innovation on the magnetic chuck on the original electrical wiring, application of the SCR of new technologies, through three months of trialerror, the initial trial in September 2071 SCR non-contact suction demagnetization device. MM7132 grinder, after years of explorationcontinuous improvement experience has shown that the device is reliable, good performance.
    销售电话:13963403599   0634-6841626
    要买到优质的广东变压器就到变压器有限公司